This is an old revision of the document!
On one of my trips to the recycling place I scored a windsurfing board. On another trip I scored an old laser sail. The obvious had to be done… a bamboo windsurfing rig!
I have written a rather wordy account of its construction at Instructables.com, so I'll spare you the details here.
Here you can see how I tried to prevent the bottom of the mast cracking (It gets a universal joint inserted). The skin was peeled off the bamboo, some superglue sprinkled on and then I wrapped twine around. The hole drilled is for the downhaul.
The two pretty curved blocks act as boom jaws to locate the boom on the mast. They are made wider than the mast to prevent crushing it when the boom is tilted. The black rubber is as padding, and made from tractor inner tube. The black rubber that goes around the bamboo is made from bike inner tube, and protects the lashings which are underneath.
Without the innertube protection, here you can see how the bamboo was joined to the cross piece. First with a big nail and then with a generous lashing of ordinary garden twine. A light sprinkling of superglue helps it stay in place and saves having to tie a knot.
The mast is simply lashed to the boom using a strip of inner tube. Never tie an actual knot in inner tube, you'll never get it out! Just tuck one end under the other, like the start of tying your shoe laces.
I tried lots of simple ideas with bits of string and blocks, but in the end made a proper universal joint. So much easier to sail now! The downhaul passes through the hole seen and prevents the universal joint from getting out of the mast.
This shows the two eyebolts that are the basis of the design. The one that goes into the pvc goes through a little block of wood screwed in the end of the pvc tube and has a washer and locking nuts on the end. It can rotate freely.
A strip of innertube is wrapped tightly around the eye bolts to keep them spaced apart, while still allowing full motion of the mast. The little ring of innertube is placed around the wrapping to keep it in place, so a knot isn't needed.