I like boats.
This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
On one of my trips to the recycling place I scored a windsurfing board. On another trip I scored an old laser sail. The obvious had to be done… a bamboo windsurfing rig!
I have written a rather wordy account of its construction at Instructables.com, so I'll spare you the details here.
watch video on Youtube
I'll start with a picture of the finished windsurfer so you know I'm not just making stuff up!<WRAP clear></WRAP>
This is the mast, a long piece of bamboo. I drilled holes in each partition, to prevent it from cracking. These are covered in tape to prevent water entering.<WRAP clear></WRAP>
Here you can see how I tried to prevent the bottom of the mast cracking (It gets a universal joint inserted). The skin was peeled off the bamboo, some superglue sprinkled on and then I wrapped twine around. The hole drilled is for the downhaul.<WRAP clear></WRAP>
The wishbone boom is also made from bamboo, with a short piece of wood as a crosspiece to keep the booms apart. The back end has just been drilled through and then lashed together.<WRAP clear></WRAP>
The two pretty curved blocks act as boom jaws to locate the boom on the mast. They are made wider than the mast to prevent crushing it when the boom is tilted. The black rubber is as padding, and made from tractor inner tube. The black rubber that goes around the bamboo is made from bike inner tube, and protects the lashings which are underneath.<WRAP clear></WRAP>
Without the innertube protection, here you can see how the bamboo was joined to the cross piece. First with a big nail and then with a generous lashing of ordinary garden twine. A light sprinkling of superglue helps it stay in place and saves having to tie a knot.<WRAP clear></WRAP>
The mast is simply lashed to the boom using a strip of inner tube. Never tie an actual knot in inner tube, you'll never get it out! Just tuck one end under the other, like the start of tying your shoe laces.<WRAP clear></WRAP>
The sail is just an old laser sail with a bit chopped off the bottom. Another bit was taken out where the boom attaches to the mast, and two new eyelets were made for the downhaul and outhaul.<WRAP clear></WRAP>
This is how you can reinforce an eyelet in a sail using a ring.<WRAP clear></WRAP>
I tried lots of simple ideas with bits of string and blocks, but in the end made a proper universal joint. So much easier to sail now! The downhaul passes through the hole seen and prevents the universal joint from getting out of the mast.<WRAP clear></WRAP>
This shows the two eyebolts that are the basis of the design. The one that goes into the pvc goes through a little block of wood screwed in the end of the pvc tube and has a washer and locking nuts on the end. It can rotate freely.<WRAP clear></WRAP>
If the eye bolts were ever to get into this position while sailing (quite likely), then stuff would break. Bad!<WRAP clear></WRAP>
A strip of innertube is wrapped tightly around the eye bolts to keep them spaced apart, while still allowing full motion of the mast. The little ring of innertube is placed around the wrapping to keep it in place, so a knot isn't needed.<WRAP clear></WRAP>
Here is the completed rig, ready to be put on the board. The yellow rope is for pulling up the sail after a spill, and is made from a rope that floats and doesn't absorb water. Big knots for grip.<WRAP clear></WRAP>
This shows the mast fitted to the board.<WRAP clear></WRAP>
Pulling up the sail is easy to do, as the rig is very light. You can see the mast bending quite a lot.<WRAP clear></WRAP>
Bye Bye!!<WRAP clear></WRAP>